Skip to Content

ECOMMERCE


  1. Products
  2. Hand Tools

Hand Tools

Marbed's Book

  • Since 2011, the Marbed's Book has been organized into three color-coded sections: 
    1. green: test bench equipment, 
    2. red: tools for pumps, 
    3. blue: tools for injectors.

  • Subcategories enable you to progressively refine your search for specific products.

 

EUR (ecommerce)
Sort By: Featured

Hand Tools

Assembly busch
Pair of assembly busch for governor cap (similar to 7144-459A)
Drive coupling
9 mm Oldham drive coupling for CP3 (FIAT) ans Siemens pumps on any test bench.
Similar to 1 685 702 090
Drive coupling
8 mm Oldham drive coupling for CP1 pumps (Mercedes) on any test bench.
Similar to BH 1 685 702 086
Comparator holder for the relief of the delivery start, on sizes A, B, BV in-line pumps.
Measurement device for the advance piston travel on Bosch VE pumps
Measurement device for the advance piston travel on Delphi DP200 pumps
Goniometer
Goniometer 180° is used to check the angle shot of the control lever of the governor RQV-K
Alignment tool
Alignment tool, oversize hydraulic head for DPA pumps. Similar to CAV / Lucas / Delphi 7144-508C
Vertical swivel vice
Swivel vice for operative flanges of PES…A,VE,VA pumps etc.
Connecting interface to drive the stroke rod of the Zexel PFR..2K pumps, on 9562-M1 cambox.
Connecting interface to drive the stroke rod of the Zexel PFR..3K pumps, on 9562-M1 cambox.
Connecting interface to drive the stroke rod of the Denso and Zexel MD/KD pumps, on 9562-M1 cambox.
Connecting interface to drive the stroke rod of the camshaftless pumps, on 9562-M1 cambox.
Bracket
Plate for BOSCH 1 cyl.pump with location clamp for determining the delivery start ratio, with rod guide
Universal basic cambox
Cambox universal base to house camshaftless pumps up to 4 cylinders on the test bench.
The cambox must be configured correctly (mounting plate, thickness - if required -, camshaft, control lever connection, sliding rod), depending on the type of pump to be tested.
Chiave a bussola dentata_
Insert external diameter 6,3 mm.with inside hole diam.2,8 mm.on Stanadyne pumps.
Bit for the governor control cover screw on DP2100 pumps. Similar to 7244-438.
Comparator holder to measure the travel on the governor magnet. Similar to 0 986 612 657
Inseritore paraolio albero comando pompa DPC
Oil seal inserter for pump drive shaft
Supporto comparatore brevettato