Se rendre au contenu

ECOMMERCE


  1. Produits
  2. Livre de Marbed

Livre de Marbed

Marbed's Book

  • Since 2011, the Marbed's Book has been organized into three color-coded sections: 
    1. green: test bench equipment, 
    2. red: tools for pumps, 
    3. blue: tools for injectors.

  • Subcategories enable you to progressively refine your search for specific products.

 

EUR (ecommerce)
Trier par : En vedette

Livre de Marbed

Supports universels pompes P et H,
Couple de supports universels plates pour la fixation des pompes P et H, simplement en mettant ou enlevant l'épaisseur de l'adaptation.
Comparator support
Holder for millesimal gauge with 70 mm diameter round top. Made in hardened, ground and lapped steel.
Flexible pipe
Flexible High pressure line L=600 mm. - M12x1,5 - M12x1,5
Flexible pipe
Flexible High pressure line L=600 mm. - M12x1,5 - M14x1,5
Porte-poussoir
Porte-poussoir pour pompes Bosch CP2. Similaire au 0 986 612 858
Kit de mésuration
Kit de mesure de la pression de transfert pour les pompes CR CP4
Accouplement cannelé pour CP3.4
Splined coupling to drive CP3.4 (MAN) pumps on any test bench.
Similar to 1 685 702 092
Demi-accouplement cannelé pour pompes CAV
Bussola 1/2 per Torx Femmina E8
Cacciavite per Torx Femmina E8
Douille
Torx bit
Similar to 0 986 613 145
Flexible pipe
Flexible pipe ( cr 2500BAR) to connect the high pressure delivery from the pump outlet to the rail. Nuts 14x15 / 14x1,5. Similar to 1 680 712 324
Estrattore per CP1
Extraction tool for the cap on the rod-type filter on common rail high-pressure pump CP1H with gear pump.
Similar to 0 986 613 165
Extracteur
Outil d’extraction pour le capuchon du filtre sur les pompes dehaute pression à rampe commune CP1H équipées d’une pompe à engrenages.
Similaire à Bosch 0 986 613 162.
Set fissaggio e trascinamento pompe CP2 (cono 30 + flangia fissaggio + flangia lubrificazione)
Lube
Unité de lubrification supplémentaire.
*** Requis si le banc d'essai utilisé n'est pas équipé d'un système de lubrification.
Centralina di lubrificazione per pompe HP0
Complementary set of fittings for pump unit 8217 on DENSO HP0 pumps (straight for G 2NE) (2x90° for NE)
Kit controllo depressione con manovuotometro.
This device allows to monitor the pump body pressure (5 BAR).
It is also equipped with ball valve, to measure the negative pressure generated by the pump.
Caution: Not all test benches are able to supply the amount of flow required by the comon rail pumps. Therefore, it is crucial to monitor that, during the test, the pump does not go into cavitation.
By-pass kit
Return by-pass set on CP2 / HP0 pumps