Skip ke Konten

ECOMMERCE


  1. Produk
  2. Hand Tools

Hand Tools

Marbed's Book

  • Since 2011, the Marbed's Book has been organized into three color-coded sections: 
    1. green: test bench equipment, 
    2. red: tools for pumps, 
    3. blue: tools for injectors.

  • Subcategories enable you to progressively refine your search for specific products.

 

EUR (ecommerce)
Sortir Berdasarkan: Featured

Hand Tools

Universal bracket
Pair of universal flat bracket to install both P and H pumps, simply by placing or removing the thickness of adaptation
Comparator support
Holder for millesimal gauge with 70 mm diameter round top. Made in hardened, ground and lapped steel.
Flexible pipe
Flexible High pressure line L=600 mm. - M12x1,5 - M12x1,5
Flexible pipe
Flexible High pressure line L=600 mm. - M12x1,5 - M14x1,5
Tappet holder for Bosch CP2 pumps. Similar to 0 986 612 858 Zexel 157931-9400
Transfer pressure Kit
Kit to determine if the ZME valve can be retained, instead of installing a new one, on CP4 pumps.
Splined coupling to drive CP3.4 (MAN) pumps on any test bench.Similar to 1 685 702 092
Splined coupling to drive CP3.4 (MAN) pumps on any test bench.
Similar to 1 685 702 092
Splined half coupling for CAV pumps
Bussola 1/2 per Torx Femmina E8
Cacciavite per Torx Femmina E8
Bussola 1/2 per Torx 50
Torx bit
Similar to 0 986 613 145
Flexible pipe
Flexible pipe ( cr 2500BAR) to connect the high pressure delivery from the pump outlet to the rail. Nuts 14x15 / 14x1,5. Similar to 1 680 712 324
Estrattore per CP1
Extraction tool for the cap on the rod-type filter on common rail high-pressure pump CP1H with gear pump.
Similar to 0 986 613 165
Puller
Extractor tool for the filter cap on CP1H common rail high pressure pumps equipped with gear pump.
Similar to Bosch 0 986 613 162.
Set fissaggio e trascinamento pompe CP2 (cono 30 + flangia fissaggio + flangia lubrificazione)
Lube
Additional external LUBE.
*** Required if the test bench in use is not equipped with a lubricating system.
Centralina di lubrificazione per pompe HP0
Complementary set of fittings for pump unit 8217 on DENSO HP0 pumps (straight for G 2NE) (2x90° for NE)
Kit controllo depressione con manovuotometro.
This device allows to monitor the pump body pressure (5 BAR).
It is also equipped with ball valve, to measure the negative pressure generated by the pump.
Caution: Not all test benches are able to supply the amount of flow required by the comon rail pumps. Therefore, it is crucial to monitor that, during the test, the pump does not go into cavitation.
By-pass kit
Return by-pass set on CP2 / HP0 pumps