234 Tools for CP4 pumps

The flange 8155-E warrants the centered clamping of the majority of cr pumps (Bosch CP1, CP3, CP4, Delphi, Denso, VDO), on any test bench.
The flange is equipped with 4 rings of reduction to suite the 50, 60, 68, 80 mm hub diameters, as well as CP1K pumps.
The flange requires 9680-A universal cradle or similar.

Swivel vice for Common-rail pumps

Flexible High pressure line L=600 mm. - M12x1,5 - M16x1,5

Kit to determine if the ZME valve can be retained, instead of installing a new one, on CP4 pumps.

This device allows to monitor the pump body pressure (5 BAR).
It is also equipped with ball valve, to measure the negative pressure generated by the pump.
Caution: Not all test benches are able to supply the amount of flow required by the comon rail pumps. Therefore, it is crucial to monitor that, during the test, the pump does not go into cavitation.

Extractor for bushings on Bosch CP4 pumps

Dukungan melingkar harus dipasang pada alas berputar (ref. 8132 atau 9260).
Sistem ini terdiri dari penyangga cincin melingkar, di mana braket (dapat dilepas) dengan proyeksi yang dapat disesuaikan dipasang, yang memungkinkan untuk menekan tappet. Dudukan melingkar memegang flensa bundar yang dapat dipertukarkan, yang dapat berputar 360 derajat dan dapat dikunci di posisi apa pun.
Flensa internal memungkinkan untuk memperbaiki pompa CP1, CP3, CP4, HP1, HP3, HP4, Delphi dan VDO.
Mirip dengan 0 986 612 794

Sebagai opsi tambahan, flensa opsional berikut juga tersedia:
- 8131, untuk pompa CP3.4
- 9402, untuk pompa mekanis A, M, VE, DPC

Key for CP4 pump. Similar to Bh 0 986 613 543

20 mm conical coupling to drive diesel pumps on any test bench, lenght 58, teeth mm 12.
The coupling is equipped with internal nut for locking and pulling out the shaft (BH 1 686 430 024)